Views: 17 Author: Site Editor Publish Time: 2022-12-02 Origin: Site
MS series single-shaft plastic shredder is specially developed for recycling companies with a large number of waste plastics. This series of single-shaft plastic shredders is equipped with a powerful, adjustable hydraulic actuator. This design prevents material clogging and reduces wear on the internal guides. The plastic shredder is equipped with an ACERETECH effective V-rotor with a diameter of 450 mm and a width of 1000 mm to 2000 m. Next, let's take a look at the introduction and installation considerations of the plastic shredder.
The following is a list of contents:
MS series hydraulic industrial plastic crusher is used for various waste plastic recycling.
What should I pay attention to when installing the plastic crusher?
The MS series single shaft plastic shredder was developed specifically for companies that recycle large quantities of scrap plastic. This series of single-shaft plastic shredders is equipped with a powerful adjustable hydraulic actuator. This design prevents material clogging and reduces wear on the internal guides. The plastic shredder is equipped with an ACERETECH effective V-rotor with a diameter of 450 mm and a width of 1000 mm to 2000 m. The hydraulic workstation is tightly integrated into the shredding chamber, saving space and protecting the hydraulic station for easy replacement and maintenance. The design of the standard V-rotor, supporting tools, knife holder, outer bearing and hydraulic screen support has been approved by customers and has received good feedback. the MS series plastic shredder can be further adapted to the design according to the customer's requirements for waste disposal. Customers can choose wear-resistant equipment such as cooling system and rotor surface hardening treatment.
MS series plastic shredders are designed to meet the requirements of various waste plastic recycling companies, including general waste recycling, electronic waste recycling, household waste recycling, processing, etc. A wide variety of recyclable materials are available, such as various plastic blocks, plastic pallets, pipes, films, woven bags, etc., as well as various electronic wire scrap, ICB drums, large electrical appliance casings, waste paper, waste wood and various organic materials. The size of the screen can be determined according to the crushed material and the next processing requirements.
The first issue is wiring. The installation of the plastic crusher includes the wiring of the plastic crusher. It is just like when we decorate the house. After the wiring is finished, it will be convenient in the house later, but if it is not done well, it will cause some trouble and inconvenience. When wiring the plastic crusher, you can first arrange the design of the switch, try to choose a convenient and safe place to add a circuit control knife to the plastic crusher machine switch to cut off the circuit. Second, the plastic crusher is fixed. Plastic crusher is a crushing equipment, so there will be a certain amount of vibration. If it is not properly fixed during installation, the vibration of the plastic crusher will increase. Due to the effects of time and resonance, loosening of the plastic crusher is an inevitable phenomenon. If we fix it firmly enough, not only the vibration of the plastic shredder will become smaller, but also more suitable for long-term production. Third, the test of the plastic shredder. Any machine must be tested after purchase and installation to prove that there is no problem with the installation. We can open the plastic shredder and then idle. After idling for a few minutes, there is no problem, which means our plastic shredder has been installed and the production work can be carried out smoothly.
We are committed to bringing more and better products to our customers, which is what we have been doing. If you are interested in a plastic shredder, you can contact us, our website is https://www.aceextech.com/, you are welcome, and look forward to cooperating with you.
